Zebra PrintServer Guide de l'utilisateur télécharger pdf (Page 23)

Installation

External PSII

4/19/07 ZebraNet PrintServer II User Guide 45537L-004 Rev. A

5. Turn on the printer.

A red status indicator blinks during the Power On Self Test (POST) and changes to green

when the initialization is finished.

The

Test button is a small hole on the PSII device. To press it, you need to insert

something small into the hole, like a paperclip.

6. Press the Test button located on the bottom of the PSII. This prints out a PSII

configuration label.

This table shows you how to determine the minimum label width needed to print a

PSII

configuration label for printers with firmware version 7 or lower:

Important • Label length, DPI and your firmware version:

• For all printers, the minimum label length is 4 in. (10.16 cm).

• For printers with firmware version 7.01 and higher, regardless of the dpi, a

2-inch (5 cm) label prints

• For printers with firmware version 7 and lower, see the table that follows.

DPI Inches

600 1.25

300 2.50

200 3.69

150 5.0

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 139 140

Pas de commentaire

Zebra PrintServer Guide de l'utilisateur Page 23