Zebra PrintServer Guide de l'utilisateur télécharger pdf (Page 26)

Installation

Internal PSII

45537L-004 Rev. A ZebraNet PrintServer II User Guide 4/19/07

1. Turn off (O) the printer and disconnect the AC power cord.

2. On the back of the printer, remove the two screws and the blank cover plate positioned

next to the main RS-232 and parallel interface connectors.

3. To remove the side panel:

•For the XiII, XiIII series, and 105SL, remove the screws and remove the left side

panel.

•For the PA X series, access the electronics by removing the mounting screws from the

printer’s PCB access panel and sliding the panel out.

4. Through the mounting slot, insert the ribbon cable and PSII.

Note • The parallel port on the back of the printer is not operational when the internal PSII

is installed. The hardware of the

PSII mounting bracket covers the parallel port.

Data Cable

Connector

Ribbon Cable

Ferrite Bead

Ribbon Cable

Test Button

Status

Indicator

Ferrite

Bead

Ribbon

Cable

Ribbon

Cable

Ferrite

Bead

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 139 140

Pas de commentaire

Zebra PrintServer Guide de l'utilisateur Page 26