Zebra DA402 Guide de l'utilisateur télécharger pdf (Page 20)

Cutter Mode (optional)

NOTE: The cutter is designed to cut through paper labels or the

backing between labels, not the adhesive backing of the label.

Adhesive build-up on the cutter blade may cause the cutter to jam.

1. Unlatch the top cover by pulling the two green release levers toward

you (refer to Figure 14). Then, lift the top cover to expose the media

compartment.

2.Separateandholdopenthemediahangers(refertoFigure15).

3. Place the media roll onto the media hangers, ensuring that it is tightly

wound(refertoFigure16).

Release

Lever

Release

Lever

Figure 14

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Pas de commentaire

Zebra DA402 Guide de l'utilisateur Page 20