Zebra DA402 Guide de l'utilisateur télécharger pdf (Page 29)

Using ZPL II

For detailed information about creating labels using ZPL II, refer to the

ZPLIIProgrammingGuideorvisitourwebsiteatwww.zebra.com.

Adjusting the Print Width

Print width must be calibrated when:

You are using the printer for the first time.

There is a change in the width of the media.

Printwidthmaybesetbywayofthefive-flashsequencein“FeedButton

Modes”(seepage31)orrefertothePrintWidth(^PW)command(consult

your ZPL II Programming Guide).

Adjusting the Print Darkness

The relative darkness setting is controlled by either the six-flash sequence in

“FeedButtonModes”(seepage31)ortheSetDarkness(~SD)ZPLII

command (follow the instructions in the ZPL II Programming Guide).

Adjusting the Print Speed

Printqualityisaffectedbyprintspeedandthemediayouareusing.Only

by experimenting will you find the optimal mix for your application.

If you find that the print speed needs to be adjusted, refer to the Print Rate

(^PR) command in the ZPL II Programming Guide.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Pas de commentaire

Zebra DA402 Guide de l'utilisateur Page 29