Zebra 170PAX2 Series Guide de l'utilisateur télécharger pdf (Page 42)

100

IP PROTOCOLS*

*Option Required

IP Protocols Press the RIGHT or LEFT BLACK OVAL key to display

other choices.

Default: All

Selections: All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP

If “dynamic” was chosen in the previous parameter, this selection determines

the method(s) by which the PrintServer II will receive the IP address from the

server. For more information, refer to ZebraNet Networking: PrintServer II

Installation and User’s Guide.

IP ADDRESS*

*Option Required

IP Address Press the LEFT BLACK OVAL key to move to the next digit

position, press the RIGHT BLACK OVAL key to increase the value of the digit.

This parameter allows you to select the IP address if “permanent” was chosen in

“IP RESOLUTION.” (If “dynamic” was chosen, the user cannot select the

address.) For more information, refer to ZebraNet Networking: PrintServer II

Installation and User’s Guide.

SUBNET MASK*

*Option Required

Subnet Mask Press the RIGHT or LEFT BLACK OVAL key to display

other choices.

Default: Permanent (user must set)

Selections: Dynamic (user may set, but server can assign), permanent

This parameter selects the part of the IP address that is considered to be part of

the local network It can be reached without going through the default gateway.

DEFAULT

GATEWAY*

*Option Required

Default Gateway Press the LEFT BLACK OVAL key to move to the next

digit position, press the RIGHT BLACK OVAL key to increase the value of the

digit.

This parameter allows you to select the IP address that the network traffic is

routed through if the destination address is not part of the local network.

LANGUAGE Selecting the Display Language Press the RIGHT or LEFT BLACK OVAL

key to display other choices.

Default: English

Selections: English, Spanish, French, German, Italian, Norwegian, Portuguese,

Swedish, Danish, Spanish 2, Dutch, Finnish, Custom

This parameter allows you to change the language used on the control panel dis-

play.

You have now completed the entire configuration and calibration sequence. You may either press the NEXT/SAVE key or

the SETUP/EXIT key.

DARKNESS You are now back at the first parameter in the configuration sequence.

NOTE: If you pressed the NEXT/SAVE key but are through programming

the printer configuration, you may press the SETUP/EXIT key and con-

tinue with the “SAVE SETTINGS” function.

Table 3: Configuration and Calibration Description (Continued)

Press Display Shows Action/Explanation

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Zebra 170PAX2 Series Guide de l'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Zebra 170PAX2 Series