Zebra 170PAX2 Series Guide de l'utilisateur télécharger pdf (Page 55)

100

Changes in parameter settings

did not take effect.

Parameters are set incorrectly. Set parameters and save permanently. Cycle the

print engine power OFF and back ON.

Incorrect ZPL format sent to the

print engine.

Check for the ^MP command. The ^MP command

can disable changes to parameters.

If problem continues, there may

be a problem with the main logic

board.

Call a service technician.

ZPL II was sent to the print

engine, but not recognized.

DATA light always OFF.

DATA light always flashing.

Communications parameters are

incorrect.

Print a Communications Diagnostic Label. Check

for format or overrun errors. Reset communication

parameters. “Setting Communication Parameters”

on page 29.

Incorrect Communications

Cable in use.

Verify proper cable and replace if necessary.

Prefix and delimiter characters

set in print engine do not match

the ones used in ZPL II format

sent to the print engine.

Set the characters in the print engine to match ZPL

II format. See “Selecting Prefix and Delimiter

Characters” on page 31.

Incorrect/incomplete ZPL for-

mat sent to the print engine.

Check the ZPL II format for changed ^CC, ^CT,

and ^CD.

Vertical image or label drift. Print engine using non-continu-

ous labels but configured in con-

tinuous mode.

Configure the print engine for non-continuous and

run calibration routine, if necessary.

Incorrectly-positioned media

sensor.

Assure the media sensor is properly positioned to

read a single/consistent inter-label gap.

Improperly-calibrated media

sensor.

Perform “Media and Ribbon Sensor Calibration”

on page 27.

Platen roller dirty. Clean the Platen roller.

Improper printhead pressure set-

tings (toggles).

Adjust the printhead pressure to assure proper

functionality.

Improperly-loaded ribbon

or media.

Verify that the ribbon and media are properly

loaded.

Incompatible media. Assure the inter-label gaps or notches are 2 mm -

4 mm and constantly placed. Also, media must not

exceed minimum specifications for mode of opera-

tion.

Table 7: Print Engine Troubleshooting (Continued)

Symptom Diagnosis Action

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Zebra 170PAX2 Series Guide de l'utilisateur Page 55

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Zebra 170PAX2 Series