Zebra RW SERIES Spécifications télécharger pdf (Page 27)

• 2-27 • RMAN-RWS-001 rev. B • RW Series Repair Procedures

Installing the Printhead

Note: Use care when handing the Printhead Assembly. The edges of the tear bar

aresharp!Avoidgettingyourngersontheglasssurfaceoftheprinthead.Always

clean the printhead after installation to remove any oils or debris that may have

accumulated during installation.

1. Install the Printhead Assembly. Insert one pivot point of the printhead into

the slot on the Printer Frame Assembly as shown at “1” below. Rotate the

printhead so that it snaps into the slot on the other side of the Printer Frame as

shown at “2”.

2. Install the (2) Springs, Printhead supplied with the repair kit to the Bar, Spring.

3. Re-assemble the Bar, Spring to the Printer Frame. Ensure that the Printhead

Springs are seated over the heads of the screws securing the tear bar to the

printhead

continued on next page

Replacement Printhead

Spares Assembly

p/n CC17411-1

(Included with RK17393-005)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 113 114

Pas de commentaire

Zebra RW SERIES Spécifications Page 27