Zebra RW SERIES Spécifications télécharger pdf (Page 47)

• 2-47 • RMAN-RWS-001 rev. B • RW Series Repair Procedures

2. Install the Radio Assembly into the Keypad and Housing. Secure it in

place with (3) screws. If the Radio assembly has an external antenna card

(RK17393-019), insert the antenna card into the upper housing.

Refer to the procedure for RK17393-008 & RK18280-1 for more details on the following steps.

4. Plug the Keypad ex circuit from the Keypad and Housing into J7 on the CPU

board. Plug the LCD ex circuit from the Keypad and Housing into J9 on the

CPU board. Ensure both connector’s locking tabs are secured.

5. Rotate the Keypad and Housing Assembly onto the lower housing of the

printer.

Ensure that you tuck the LCD and Keypad Flex circuits behind the edge of the CPU

Board before securing the two housings.

If the Radio assembly has an external antenna card (RK17393-019), ensure the

antenna card is seated into the lower housing before securing the Keypad and

Housing Assembly. Align the two housings and press the Keypad and Housing

rmly into place. Secure the housings together with the (6) screws you

retained when removing the Keypad and Housing.

6. Re-assemble either the “D” rings or the carrying strap between the upper and

lower housings before securing the two housings with the long screws. Refer

to the procedure for RK17393-023 for more details.

Plug Keypad Flex

Circuit into J7.

Plug LCD Flex

Circuit into J9.

Rotate reassembled

Keypad and Housing

Assy. into place on

lower housing.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 113 114

Pas de commentaire

Zebra RW SERIES Spécifications Page 47