Zebra RW SERIES Spécifications télécharger pdf (Page 50)

RMAN-RWS-001 rev. B • RW Series Repair Procedures • 2-50 •

NOTES:Theconnectorforthemotorcableispolarized.Itwillonlytinonedirection.Donot

try to force the connector in place.

Flex cables install in zero insertion force (ZIF) connectors. Pull the connector open,

insert the cable, and close the connector to retain the ﬂex cable.

Dress the motor cable away from mounting bosses so they won’t get pinched during

the next assembly steps.

3. Ensure that the latch release button moves in and out freely.

Secure the CPU Board. Secure the Controller Board in place with the (2) Screws

supplied in the kit.

4. Install the Upper Housing. Refer to the procedure for kits RK17393-008 and

RK18280-1 for more details.

Test the Printer

1. Install the Battery Pack.

2. Load the application. You must reload the printer’s original application les.

These les can be stored either on your local system or can be downloaded

from the factory’s database.

YoumusthaveauthorizationfromZebratoaccesstheapplicationlesfromthe

factory.

3. Calibrate the Sensors. Using the gray and white swatches, follow the on-screen

instructions on the unit test and set-up software to properly calibrate the

sensors.

Press Latch release

button while installing

Controller Board

J10

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 113 114

Pas de commentaire

Zebra RW SERIES Spécifications Page 50