Zebra ZD500 Guide de l'utilisateur télécharger pdf (Page 34)

Setup

Loading Roll Media

P1062653-002 Rev. A ZD500 Series™ Thermal Transfer Printer User’s Guide 1/16/2014

4. Pull the media so that it extends out of the front of the printer. Verify the roll turns freely.

The roll must not sit in the bottom of the media compartment. Verify that the media’s

printing surface is facing up.

5. Push the media under both of the media guides.

6. Close the printer. Press down until the cover snaps closed.

Your media may need a ‘Manual Calibration’ to adjust the printer’s sensors and label length

setting to operate properly. See the Manual Calibration - Media on page 75. If you are using

RFID media, run a RFID Calibration procedure, see the RFID Menu on page 65 - RFID

CALIBRATE for details.

Under Media

Guides

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 159 160

Pas de commentaire

Zebra ZD500 Guide de l'utilisateur Page 34