Zebra ZD500 Guide de l'utilisateur télécharger pdf (Page 65)

Printer Configuration

Changing Printer Settings

1/16/2014 ZD500 Series™ Thermal Transfer Printer User’s Guide P1062653-002 Rev. A

Tear-Off

Position

If necessary, adjust the position of the media extending out of the printer after printing.

• Higher numbers move the media out (the tear line moves closer to the leading edge of

the next label).

• Lower numbers move the media in (the tear line moves closer to the edge of the label

just printed).

• Note - Tear-Off does not affect RFID program position.

Accepted values:

–120 to 120

Related ZPL command(s):

~TA

SGD command used:

ezpl.tear_off

Printer web page:

View and Modify Printer Settings > General Setup >

Tear Off

Print Width Specify the width of the labels being used. The default value is the maximum width for the

printer, based on the printhead’s DPI value.

Note • Setting the width too narrow can result in portions of a label format not being

printed on the media. Setting the width too wide wastes formatting memory and can

cause the printer to print off of the label and onto the platen roller. This setting can

affect the horizontal position of the label format if the image was inverted using the

^POI ZPL II command.

Accepted values:

0000 to 0832 dots (200 dpi printers)

0000 to 1280 dots (300 dpi printers)

Related ZPL command(s):

^PW

SGD command used:

ezpl.print_width

Printer web page:

View and Modify Printer Settings > Media Setup >

Print Width

Table 7 • SETTINGS Menu (Continued)

Media direction

Factory-set tear line location at position 000

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 159 160

Pas de commentaire

Zebra ZD500 Guide de l'utilisateur Page 65