Zebra MP6000 Spécifications télécharger pdf (Page 121)

SITE PREPARATION AND INSTALLATION 3 - 31

Cutout/Dimensions - MP6000 Long (continued)

Figure 3-40

MP6000 - Long Unit Top View Dimensions

To install the MP6000:

1. Ensure the following items were completed:

a. Existing scanner and accessories were removed, if applicable. See Remove Existing Bioptic Scanner

and Accessories on page 3-7.

b. Cables were connected and routed. See Cables and Connections on page 3-15.

c. The Scale Display was installed, if applicable. See Install the Scale Display on page 3-12.

d. CSS was installed, if applicable. See Install the Customer Side Scanner (MX101) on page 3-16.

e. Sensormatic coil, or Checkpoint EAS antenna was installed, if applicable. See Install Sensormatic

Coils on page 3-34, or Install Checkpoint Antenna on page 3-37.

2. Verify checkstand dimensions shown in Figure 3-30, Figure 3-34, and Figure 3-38, respectively.

3. Lower scanner in checkstand as follows.

a. Remove the platter to access the front handle of the device (see Installing/Removing the Long Scale

Platter on page 5-8).

b. To grasp the MP6000 to lower it into the checkstand, use the support handle on the back of the tower

cover together with the front part of the scale, or the handle in the front flange area (if installing the long

model). See Figure on page 3-32.

11.50 in.

292.2 mm

20.0 in.

506.9 mm

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 209 210

Pas de commentaire

Zebra MP6000 Spécifications Page 121