Zebra MP6000 Spécifications télécharger pdf (Page 97)

SITE PREPARATION AND INSTALLATION 3 - 7

Remove Existing Bioptic Scanner and Accessories

If you are replacing existing equipment, follow these step to remove the old unit:

1. Ensure the POS is logged off, and the drawer was cleared by the store personnel. This varies by location.

Some IT Departments may require the POS to be completely shut down.

2. Unplug the current bioptic scanner from its power supply.

3. Prior to removing cables, make a note of the current cable runs.

4. Remove all cables connected to the bioptic scanner. Do not cut cables if you are using, or selling the old

equipment.

5. If applicable, unplug the current hand-held device from its power supply, and disconnect it from the current

bioptic scanner/host.

a. If reusing the hand-held device, leave its cable runs intact.

b. If the hand-held device was attached to the bioptic scanner with an RS-232 cable, a new cable and a

new hand-held device configuration is required.

6. If a Sensormatic connection is present, there are two cables to be aware of:

a. The large cable to the coils/antennas - disconnect from the current bioptic but leave in place.

b. The RS-232 cable to the Sensormatic controller communications port - use its run to assist replacing it.

7. If a Scale Display is present:

a. Make a note of how the current display was mounted and determine if the current placement can

accommodate the new Scale Display. Adjustments to the layout, and cable run may be required.

b. Unplug the old Scale Display power.

c. Remove it from the checkstand.

d. Remove its cables.

e. Remove the Scale Display.

8. Remove the existing bioptic scanner.

Unpacking MP6000 Equipment

To unpack equipment:

1. Remove all components from their packaging, and check that all parts are present. Each box includes the

material listed in Table 3-1. Each of the items listed is contained in separate packaging within the box and

is recognizable as a discrete item. Power cables, host to scanner communications cables, leveling screws,

and trim filler kit are all sold separately in kits.

Table 3-1

MP6000 Box Contents

Description Part Number

MP6000 w/o Platter MP6xx0-xx000M010xx

Platter 22-159817-xxx

Checkpoint Antenna 10-162248-xx

Regulatory Guide 72-171321-xx

NOTE An optional Scale Display, p/n MX201-SR00004ZZWR, is available separately for scale models only.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 209 210

Pas de commentaire

Zebra MP6000 Spécifications Page 97