Zebra MP6000 Spécifications télécharger pdf (Page 167)

OPERATING THE SCANNER 5 - 13

Loading Cloning Files

Cloning files can be loaded to the staging flash drive two ways:

•

Insert the staging flash drive into one of the MP6000 USB ports (Figure 5-10), and select Option 1 - Load

Files (s

ee Step 3).

•

Use 123Scan

to create and export files to the staging flash drive. (See 123Scan2 Staging Flash Drive

Configuration for more information.)

Follow the steps below to clone data.

1. Insert the staging flash drive in the USB port under the MP6000 platter.

2. When the staging flash drive inserts correctly, the MP6000 detects the drive, and sounds two beeps

(low/high).

3. The MP6000 identifies the data on the USB flash drive, and the 7-segment display shows a flash drive

menu sequence. The flash drive menu displays three number options for approximately five seconds each.

See MP6000 Menu Structure for the USB Staging Flash Drive on page 5-11 for menu options.

4. When the option you desire displays in the menu, you have five seconds to select the option by pressing

the EAS button (see EAS Deactivation Button (Sensormatic only) on page 1-9). One, two, or three beeps

sound, depending on the option selected.

5. You have 15 seconds to confirm the selection by pressing the EAS button again. (If the selection is not

confirmed, four fail beeps sound, and the 7-segment display re-scrolls the menu.)

6. After confirmation, the 7-segment display shows a scrolling bar (

). This means the device is working.

When the process is complete (time varies) three success beeps (high/low/high), or four failure beeps

sound, and the scrolling bar stops. Removing the staging flash drive at this point sounds the success or

failure beeps again from the last operation performed.

NOTE The USB flash drive must be at least 2.5 in. (63.5 mm) long to be accessible for removal after insertion

into the internal MP6000 flash drive well. Alternatively, some USB flash drives include an opening in their

rear covers into which a paper clip can be looped to help achieve the minimal length dimension.

See Approved USB Flash Drives for the Flash Drive Well on page 5-14 for the recommended flash drive

dimensions for use in the internal USB port.

It is recommended to start with a clean flash drive.

NOTES 1. If EAS was installed and operational, the EAS button remains lit. If EAS was not installed,

and/or not operational, the EAS button on the front panel of the MP6000 lights when the

staging flash drive is inserted.

2. While the staging flash drive is inserted:

a) Do not remove power.

b) Do not remove, or connect any cables.

c) Do not press the Volume or Scale buttons.

These actions may interfere with the staging flash drive process.

NOTE The scrolling bar stops whether or not the cloning process succeeded or failed. If the

process failed, try again or contact the System Administrator.

If the staging flash drive is removed prior to completion, a fail occurs (four beeps

sound). Premature removal of the staging flash drive may result in a partial change in

the system.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 209 210

Zebra MP6000 Spécifications Page 167

Commentaires sur ces manuels