Zebra II Spécifications télécharger pdf (Page 247)

c = enable “condition set” alert to this destination

Accepted Values: Y (yes) or N (no)

Default Value: Y or previously configured value

d = enable “condition clear” alert to this destination

Accepted Values: Y (yes) or N (no)

Default Value: N or previously configured value

Parameters e and f are sub-options based on destination. If the sub-options are

missing or invalid, these parameters will be ignored.

e = destination setting

Accepted Values:

Internet e-mail address (e.g. [email protected])

IP address (e.g. 10.1.2.123)

SNMP trap

IP or IPX addresses

f = port number

Accepted Values:

TCP port # (0 to 65535)

UPD port # (0 to 65535)

Examples:

Serial: ^SXA,A,Y,Y

Parallel: ^SXA,B,Y,Y

E-Mail: ^SXA,C,Y,Y,[email protected]

TCP: ^SXA,D,Y,Y,123.45.67.89,1234

UDP: ^SXA,E,Y,Y,123.45.67.89,1234

SNMP Trap: ^SXA,F,Y,Y,255.255.255.255

Comments: In the example above for SNMP Trap, entering 255.255.255.255 will

broadcast the notification to every SNMP manager on the network. To route the

device to a single SNMP manager, a specific address can be entered (123.45.67.89).

ZPL II Programming Guide Volume One: Command Reference for X.10

239

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 261 262

Pas de commentaire

Zebra II Spécifications Page 247